C-Bus 5200PG Spécifications télécharger pdf (Page 19)

Wiser Home Controller Installation Instructions

3.7 Step 4, Connect your Configuration PC

You can now connect and test the connection to the customer's C-Bus

network using the Wiser Home Controller and the inline CNI.

1. Connect the configuration PC to one of the open RJ-45 LAN

connectors on the Wiser Home Controller. You may use the Wiser

Home Controller's wireless LAN, if preferred.

2. Connect the power supply wire to the busbar power port. Plug the

power supply unit into a wall power outlet.

Use only the power supply provided with the Wiser Home

Controller. Using a different supply unit might cause product

damage or erratic performance.

After you have connected the configuration PC and C-Bus network, you can

use the LEDs on the Wiser Home Controller's router and CNI to verify LAN

and C-Bus network connections (See Section 4). If you have problems,

check all signal and power connections.

Monitor the Indicator Lights

When the Wiser Home Controller unit is powered on, the router performs a

self-test cycle. During the cycle, the Diag lamp is on. It might take a minute

or two for the light to go out. The Diag lamp might flash intermittently, but

after initialisation it should not be on continuously.

Other lights on the router indicate Internet, LAN and wireless activity. Refer

to Figure 10 and Table 4 for more information.

Figure 10. Location of LEDs on the Wiser Home Controller

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 49 50

Pas de commentaire

C-Bus 5200PG Spécifications Page 19